Bores only the required number of adjustable shelf holes.Construction pilot hole boring for #6 x 1 3/4 inch assembly screws (can be switched on/off).Cabinet backs, drawer and rollout-tray bottoms are sized for thickness and set into dadoes.Material thickness variations go to the inside of the cabinet body vertically, holding the tops and bottoms flush with the ends. The TenonCam System produces a fully milled tenon, orientated exterior face down to the spoil board with a fixed mortise location.
#Nested cnc dovetail drawer bit install
Therefore, ball bearing type, side mount drawer guides will install without shimming or shaving. This ensures that any material thickness variation will go to the outside of the cabinet body horizontally. The tenon shoulders hold the cabinet body interior horizontal opening to net size.Cabinet body mortise and tenon joints are machined In-the-Nest with Specialized Tooling, which eliminates double handling and the need for secondary operations and machinery.
#Nested cnc dovetail drawer bit software
Please refer to the drawings at the bottom of this page for further clarification.
This ensures that the mortise and tenon joints will be flush, and allows additional machining to be done without having to remove parts from the nest. All other cabinet parts are orientated exterior face down to the spoil board. The TenonCam router bits are available for: 1 inch, 3/4 inch, 5/8 inch and 1/2 inch thick material.Ĭabinet backs and drawer bottoms are machined interior face down to the spoil board, so they can be sized for thickness. The software allows tenons to be cut anywhere In-the-Nest. The picture above is of a TenonCam router bit, shown cutting a tenon on a cabinet bottom. No double handling or secondary machining. The concept is to put a 4 x 8 sheet of material on the Router, process it, and then take completely milled, cut to size, parts off the Router. This process is used to produce completely milled cabinet, drawer and toe board parts, without secondary operations or supporting machinery. TenonCam is a manufacturing system, consisting of patent pending router bits and software, used to form mortise and tenon joints, In-the-Nest, on a flat table CNC Router.